Saturday, September 6, 2025

Update 3D Model to Support the Touch Screen

I have toiled over getting the model just right to accommodate the parts and look decent. It took nearly 25 revisions but I think its at a point I can release it to the public. I have built a few now using this enclosure and it works well. It is separated into three separate parts: main enclosure, orb holder, and base to facilitate printing and is easy to assemble. You can download the .stl file at printables.com to try it out for yourself. 


On a side note, I have built several prototypes and am refining my instructables guide with each revision to make sure I did not miss any important details. I hope to release that soon as well. Until next time, stay stoked!

at

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)

Snow Plough backend.

I have the Snow Plow backend running on  vps.snowscraper.ca  that will do the heavy lifting of scraping sites. Especially those with dynamic...

  • Whistler snowfall data added.
    I've had success writing the code to scrape Whistler's snow data! It was stored in a different format but I managed to get it with a...
  • First completed prototype
    Here is an up close image showing the display on a day with no new snowfall:  This is an image from afar after nine centimeters had fallen:
  • AI generated prototypes
    I used Microsoft's new designer AI tool to generate some potential prototypes for my vision of the Snow Scraper. Here are a few of the b...